Archives

The performance of CompactPCI is vastly improved with the CPSB (PICMG 2.16) protocol. CPSB increases system performance by moving data traffic off the shared bus, and onto an embedded switched Ethernet network fabric (10/100/1000 Mbit/s), accessed via the P3 connector.

FEATURES:
– Conforms to PICMG 2.16 specification
– Conforms to PICMG basic specification 2.0 R3.0
– Switched via Ethernet fabric (10/100/1000 Mbit/s)
– Optional power supply connectors or power bugs
– Supports existing SBCs, Ethernet cards, and line cards
– 12-layer controlled impedance stripline design

Available with a choice of PowerPC or Pentium on 6U CompactPCI or PICMG 2.16 boards. Choice of on-board PMCs according to slot availability and requirements. Rear I/O transition modules with PIMs (PMC Interface Modules) for maximum system configurability. Configured for VxWorks, Linux, Windows or Solaris OS with driver support. Compact, 4U (7″) chassis with 6 CompactPCI or PICMG 2.16 slots.

Features:
· 14 slot mixed backplane: two PICMG 2.16 fabric slots, and two PICMG 2.16 system node slots
· Choice of a PowerPC or Pentium Single Board Computer
· Choice of one or two 10/100 or Gigabit Ethernet switches, managed or unmanaged
· Choice of storage solutions in PMC, cPCI form factor
· ACT Technico’s RAIDStor for a 6U Network Attached Storage Development Kit
· 19″ rackmount enclosure, 10U High, 21″ deep
· Two 600W redundant power supplies provided (up to 1800 watts available)
· Hot swap removable fan tray with 274 CFM cooling capacity (350 LFM average airflow)
· 6U module with provisions for 1 floppy drive, 1 hard drive and 1 CD drive
· Configured for VxWorks, Linux, Windows or Solaris OS with driver support

The Elma Bustronic Low Profile cPCI backplane series saves a slot-size of width on the backplanes. By placing power studs and power blades throughout key locations, as opposed to the side of the backplane, space is saved. This allows the 4-slot Low Profile cPCI to fit within a 2U horizontal chassis and the 8-slot to fit within a 4U horizontal chassis, etc.
All Elma Bustronic cPCI backplanes are designed to be fully compliant to the PICMG basic specification 2.0 R3.0 and Hot Swap specification 2.1 R1.0. The H.110 versions conform to PICMG H.110 Computer Telephony specification 2.5 R1.0. Some configurations are compliant to the PICMG 2.16 Packet Switching Backplane specification.
Elma Bustronic uses stripline construction to assure the highest possible performance. By exclusively utilizing stripline construction, we eliminate a significant source of EMI/RFI radiation and give all signals similar characteristic impedances and minimal signal skew. This allows for significantly higher data transfer rates as signal skew factors into the rate calculations four times.

FEATURES:
– Conforms to PICMG basic specification 2.0 R3.0
– PICMG Hot Swap specification 2.1 R1.0
– Versions conforming to PICMG 2.16 are available
– Versions conforming to PICMG 2.5 R 1.0 for Computer Telephony are available
– Designed to save a slot size of width, fit into low profile horizontal chassis
– 8-layer and 10-layer controlled impedance stripline designs
– Virtually zero crosstalk