Archives

July 8, 2016

AMC534

The AMC534 is an FPGA with dual zQSFP+ connectors offering 100G performance (Port 0 at 100G, Port 1 up to 40G) via the front panel. The module is compliant to the AMC.1, AMC.2, and/or AMC.4 specification. It has an on-board, reconfigurable FPGA which interfaces directly to the AMC FCLKA and TCLK A-D. The FPGA has interfaces to four DDR3 memory channels (32-bit wide each) with 1 GBytes per channel and a 4 GBytes total size. This allows for large buffer sizes to be stored during processing as well as for queuing the data to the host.

The on-board quad-core P2040 can run at 1.2GHz with 2 GBytes of DDR3, 128 Mbytes of Boot Flash, and a 32 GByte SD Card. The PPC has an x4 PCIe interface to the FPGA in addition to its local bus. The PPC has its dual GbE routed to ports 0 and 1 of the AMC.

July 8, 2016

AMC593

The AMC593 provides a very capable I/O processing engine, with a large UltraScale FPGA coupled to two FMC sites and supported by an on-board quad-core processor. Withover 5,500 DSP slices and supported by 8 GB of DDR4 (32-bits wide over two banks), the XCKU115 connects to all FMC LA/HA/HB pairs, balancing high-speed I/O with impressiveprocessing power. The AMC593 is compliant to the AMC.1, AMC.2 and/or AMC.4 specification, and supports direct AMC-to-AMC connections over ports 12-15 and 17-20.

The dual FMC sites accept FMCs from VadaTech’s extensive range of data acquisition,networking and RF units, and other 3rd party VITA-57 compliant modules.The quad core P2040 on-board host has 4x PCIe interface to the FPGA in addition to its local bus, and is supported by DDR3, Boot Flash and a SD Card. The user can select whether to route ports 0 and 1 of the AMC to the PPC or FPGA.

The AMC593 has Serial over LAN (SOL) per IPMI specification, with a hardware RNG for secure session.

July 8, 2016

AMC592

The AMC592 is an AMC FPGA Carrier with an FMC (VITA 57) interface. The unit has an on-board, re-configurable UltraScale FPGA which interfaces directly to the AMC FCLKA, TCLKA-D, FMC DP0-9 and all FMC LA/HA/HB pairs. The FPGA has interface to three banks of DDR4 memory channels. This allows for large buffer sizes to be stored during processing as well as for queuing the data to the host.

The AMC592 is compliant to the AMC.1, AMC.2 and/or AMC.4 specification, and supports direct AMC-to-AMC connections over ports 12-15 and 17-20.

The AMC592 has a single FMC connector to accept FMCs from VadaTech’s extensive range of data acquisition, networking and RF units, and other 3rd party VITA-57 compliant modules.