Four IP module slots. Rear access I/O. Plug-and-play carrier configuration and interrupt support.
The AcPC8625A is a nonintelligent slave board that interfaces four IP modules to the CompactPCI (cPCI) bus.
All 200 I/O points are brought out the rear J4 and J5 connectors. This convenience eliminates messy cables from hanging out the front of the cage. In addition to a more efficient cage wiring design, it is also much easier to insert and replace boards. And with Acromag’s 80mm transition module (TRANS-C200), all 200 I/O points are easily ported out the back of the cage.
Performance Specifications
Acromag’s carrier boards provide full data access to the IP module’s I/O, ID, interrupt spaces, and memory. With full access to the programmable registers, you can easily configure and control the operation of the IP modules from the CompactPCI bus.
Up to two interrupt requests are supported for each IP module. All board interrupts are mapped to PCI bus INTA# signal.
Individual passive filters on each IP power supply line provide optimum filtering and noise isolation between the IP modules and the carrier board.
IP Compliance (ANSI/VITA 4): Meets IP specs per ANSI/VITA 4-1995 (8MHz and 32MHz) and IP I/O mapping to PICMG 2.4 R1.0.
Electrical/mechanical interface: Supports single or double size IP modules. 32-bit IP modules are not supported.
IP Module I/O space, ID space, INT space, and MEM space supported.
Interrupts: Supports two interrupt requests per IP module and interrupt acknowledge cycles via access to IP INT space.
CompactPCI bus Compliance: Meets PCI spec. V2.1 and PICMG 2.0, R2.1.
Features and Benefits
Four industry-standard IP module slots
Board resides in memory space
Supports IP module I/O, ID, INT and MEM spaces
200 I/O points with rear access
High-density rear connectors
Compatible with all CompactPCI CPUs
Plug-and-play carrier configuration and interrupt support
Two interrupts per IP module
Front panel LEDs
Supervisory circuit for reset generation
Individually filtered and fused power to each IP
Ruggedized with ESD strip and EMC front panel
Easily integrate IPs with your software using RTOS VxWorks, Linux, or Win DLL for Windows® 2000/XP/Vista/7 32-bit systems
